Bring it to our Winter Haven shop and we'll handle the wheel bearing replacement. Here's where to find us, when we're open, and how to book a time.
Address, hours, and directions for the shop that handles your wheel bearing replacement.
Mon to Fri, 7:30 AM to 5:30 PM; Sat and Sun, closed
Wheel Bearing Replacement
November 2026 · Winter Haven
The vehicle owner stated the trailer needed a wheel bearing on the r.r wheel.
The technician started with an initial assessment at no charge and updated the service manager. The wheel bearing and hub assembly on the trailer's r.r wheel was removed and replaced, with components taken apart as required to access and install the new parts.
Wheel Bearing Replacement
October 2026 · Winter Haven
2014 Ford Fiesta
The vehicle owner stated the vehicle had a bad wheel bearing and asked the shop to check and advise.
The technician began with an initial assessment at no charge, as the shop does before further testing. The wheel hub and bearing assembly was then removed and replaced at our Winter Haven shop, with lug nuts included on the work performed.
Wheel Bearing Replacement
October 2026 · Winter Haven
2019 Subaru Crosstrek
The vehicle owner asked the shop to look at a possible wheel bearing repair and to do an LOF.
At our Winter Haven shop, the technician began with an initial assessment, which was done at no charge. The team then performed a Wheel Hub And Bearing Assembly Remove & Replace on the driver's front. An LOF oil change with full synthetic oil to vehicle specs was done during the same visit.
More ways we can help in Winter Haven.
Answered by our technicians serving Winter Haven.
Early on, a quiet hum is not an emergency, and we're not going to tell you the wheel is about to fall off. What we will tell you is that the repair gets more expensive the longer it runs, because heat damages the hub and the knuckle around it. Once you can feel it as well as hear it, get it in.
Usually. A road test with lane changes narrows it down, and on the lift we spin each wheel and check for roughness and play. Between those two we can normally name the corner before we quote it.
No. Bearings fail individually, often because of one impact or one bad seal, so we replace the one that's actually bad. If the other side is also rough we'll show you why and let you decide, but we won't sell you two on principle.
It can, though a vibration that changes with speed is more often tires, wheels or balance. If shaking is your main complaint rather than noise, the vibration diagnosis route is the better starting point, because we'd rather find the cause than replace a bearing and leave the shake.
ASE Certified Technicians
ASE certified techs working on your vehicle
Flexible Drop-Off Hours
Convenient service options
20+ Years
2 decades of trusted service
